Plasmon LIBRARIES D2175, User Manual, Page: 82 / 90

Appendix D Plasmon D875 - D2175 User Manual
Page 80 Document Revision E
8D 1 No media to flip-
per No media in tray to flip-
per for move medium
command Need media Provide media for use
2 No media in source ele-
ment to flipper for
exchange medium
command
3 No media in destina-
tion element to flipper
for exchange medium
command
90 1 Tray in drive Tray in a drive while
attempting to park Drive Drive has tray, either in ser-
vice mode, or bad drive
9C 1 Tray magazine
unknown Source magazine for
tray unknown when
returning trays to there
last known elements Recovery
9D 1 Element scan
fail Failed to position lift or
picker properly while
checking elements. Alignment
problem Run offsets
2 Invalid Element (current
element check)
B2 1 Flipper invalid
position Both flipper home sen-
sors blocked Flipper Replace flipper
B3 1 FS EEPROM
write fail Write flipper EEPROM
status failed Flipper, mag
interface cir-
cuit board Replace flipper or mag inter-
face
B4 1 Missing flipper
tray No tray in flipper
(at least one required) Replace tray
B5 1 Flipper is full Both slots of flipper
have trays Remove tray
B6 1 Flipper comm
error Time out for flipper sta-
tus command Flipper, mag
interface cir-
cuit board Replace flipper or mag inter-
face
2 Time out for flipper read
version command
3 Time out for flipper read
sensors command
Error
Code
(hex)
Sub-
code
Error
Description
Subcode
Description
Compo-
nent
Corrective Action