Plasmon LIBRARIES D2175, User Manual, Page: 74 / 90

Appendix D Plasmon D875 - D2175 User Manual
Page 72 Document Revision E
5 Checking a SCSI posi-
tion to drive command
32 1 Drive not con-
nected Drive not connected
that was previously
installed Drive inter-
face cables Replace or reconnect drive
cables
2 Drive not connected
when restoring drives
33 1 Drive clamp fail Drive clamp fail while
loading drive Drive, drive
cables Replace drive or cabling
34 1 Drive unclamp
fail Drive unclamp fail
unloading drive retry Drive, drive
cables Replace drive or cabling
35 1 Drive load fail Tray not seen in picker
while picker moving to
load position MTE sensor Replace MTE
2 VP or Tray sensor
blocked after retracting
picker to fwd position MTE sensor,
VP sensor Replace MTE, VP sensor, run
offsets to correct positioning
3 Drive not set to loaded
4 Drive load retry aborted
36 1 Drive unload fail Drive not unclamped Drive, drive
cables Replace drives or cables
2 Pick finger did not hold
on to tray, VP or Tray
sensor blocked Alignment
problem Run offsets
3 No tray seen in unload
attempt Alignment
problem,
MTE tray
sensor Run offsets, replace MTE
4 Picker Tray sensor
blocked during tray only
check of drive unload Alignment
problem,
MTE tray
sensor Run offsets, replace MTE
5 Picker Tray sensor
unblocked during tray
only check of drive
unload Alignment
problem,
MTE tray
sensor Run offsets, replace MTE
37 1 Drive is clamped Drive is clamped, can't
unclamp (checking
move from a drive)
Drive, drive
cables Replace Drive, drive cables
Error
Code
(hex)
Sub-
code
Error
Description
Subcode
Description
Compo-
nent
Corrective Action