Copyright Planika Sp. z o.o.
www.planikafires.com
4
III.
Safety
As
PrimeFire
produce a real open fire it is necessary to follow the below specified rules in order to enable the product to
be used in a technically correct and safe manner as well as to maintain the warranty.
•
When installing the device according to the instructions, you must comply with national and local regulations.
•
It is required to read the installation instructions in order not to use the device in an improper manner or in rooms with
smaller cubic capacity than required.
•
Products should not be exposed to atmospheric conditions. It’s the product for internal use only.
•
When turned on, the device produce steam, carbon dioxide and heat, therefore it’s necessary to provide adequate
ventilation so that the total replacement of the air in the room is min. 1 / h.
•
Do not use the device in the temperature lower than 10°C and higher than 30°C.
•
Do not install the device in areas of large drafts of air, near fans, vents, etc.
•
Do not install the device on escape routes and in places where there may be potentially explosive atmospheres.
•
The device as well as the fuel should be kept out of reach of children, pets and unauthorized persons.
•
It is forbidden to consume the fuel. Avoid contact with skin and eyes.
•
It is required to take precautions when dealing with flammable materials, for example in direct contact with object,
or in area within 1 m / 3.28 ft. around the device no flammable objects should be placed. Do not place near the curtains,
blinds, etc.
•
Do not place on the grid any elements not provided by the producer.
•
It is necessary to place dry-powder or carbon dioxide extinguisher near the device.
•
The device should be installed only on flat, level and firm surface.
•
Positioning the device on a sloping ground may cause malfunction, damage to the device or fire.
•
It is forbidden to use other fuel than recommended fuel FANOLA or the fuel recommended in section II Supplies and
consumables.
•
Do not heat the fuel before the heating process of the device is started.
•
Do not start the device in case of spillage of fuel out of the tank.
•
Never pour fuel directly into the flame tray as this may cause damage to the device and result in fire. Such an attempt
may cause violent ignition, result in fire, burns, and can even be life threatening.
•
Do not cover the device while it is switched on.
•
Do not operate near the fuel filler while the device is switched on.
•
Do not operate with the components contained within the flame tray under the threat of burns or damage to the device.
•
Do not move the device while it is switched on. The device can be moved only after the complete combustion of the fuel,
when it is disconnected from power supply and when all its elements are cooled.
•
The device should not be left without adult supervision while it is switched on.
•
The device should be kept out of reach of untrained users.
•
The device must be switched on and used as per description in point IV in instructions.
•
While switching on the device, the odor of fuel may be perceptible.
•
The device is not suitable for continuous operation. If the device suddenly turns off, proceed in accordance with the
instruction.
CAUTION!
•
Glowing coil is heated to a temperature of 1300 ° C. Touching, when the device is switched on may cause burns.
•
While working the flame tray is heated to high temperatures. Do not touch the flame tray or hot parts located in close
area under the risk of burn injury.
•
The first startup of the device can be made only after proper installation of the device and reading the manual.
•
If the device requires transport it is required to burn all fuel remains and move it in a horizontal position, avoid tilting it.
As the unburned fuel remains in the combustion chamber, during the transfer sensors could be activated. In this case,
the device could be used again only after it has dried completely.
It is forbidden to make any repairs or changes in the device. Repairs may be made only by professional technician.
!
!
