13
Step 3.
Check your list of Network Components in the Network
window Configuration tab. If TCP/IP has already been in-
stalled, go to Step 8. Otherwise, select Add to install it now.
Step 4.
In the new Network Component Type window, select Pro-
tocol.
In the new Select Network Protocol window, select Micro-
soft in the Manufacturers area.
Step 5.
In the Network Protocols area of the same window, select
TCP/IP, then click OK. You may need your Win95/98 CD
to complete the installation. After TCP/IP installation is
complete, go back to the Network window shown in Step 4.
Step 6.
Select TCP/IP in the list of Network Components.
Step 7.
Click
Properties
, and check the settings in each of the TCP/IP
Properties window:
Bindings Tab
: both
Client for Microsoft Networks
and
File
and printer sharing for Microsoft Networks
should be se-
lected.
Gateway Tab
: All fields should be blank.
DNS Configuration Tab
:
Disable DNS
should be selected.
IP Address Tab
:
Obtain IP address automatically
should be
selected.
Step 8.
With the GW-AP54SAG powered on, reboot the
PC/wireless client. After the PC/wireless client is re-booted,
you should be ready to configure the GW-AP54SAG. See
Chapter 3.
The procedure required to set a static IP address is not too much different from the procedure
required to set to “obtain IP addresses dynamically” - except that at the end of step 7, instead
of selecting “obtain IP addresses dynamically, you should specify the IP address explicitly.
Summary of Contents for GW-AP54SAG
Page 1: ......
