34
34
10 Taking out of operation
To keep the hoist trolley unit in good condition when taking out of service for a period longer than
one month, follow the steps below.
Attention!
If the hoist trolley unit is taken out of service for a period longer than six
months read chapter 4 “Transport and Storage” section storage.
-
The hoist trolley unit may only be taken out of operation in unloaded condition.
-
Perform routine maintenance and maintenance for taking out of operation
according to maintenance table 1 and 2 of chapter 8.1 “Maintenance schedule”.
-
The environment should be clean and dry.
-
If necessary, the hoist trolley unit shall be cleaned.
-
The hoist trolley unit shall be kept free from excessive vibrations.
-
The hoist trolley unit shall be protected against excessive water, wind and salt
-
The hoist trolley unit shall be stored in a closed and/or sealed packing.
-
Observe environmental protection laws (do not allow oil etc. to leak).
Model K
-
Temperature not colder than -20°C or hotter than +40°C.
Model N
-
Temperature not colder than -15°C or hotter than +40°C.
Dismantling
When an hoist trolley unit or its components have reached their end of service live, they shall be
replaced or taken out of service. When taking an hoist trolley unit or its components out of service
they shall be dismantled according to the instructions below.
Warning!
Dismantling may only be carried out by competent persons!
Attention!
Before dismantling:
-
Read chapter 2 “Safety instructions”.
-
Read chapter 7 “Operation” for use of personal protective equipment.
Depending on the situation, the hoist trolley unit can be dismantled in two ways. If the ends of the
monorail aren’t accessible, due to a wall or other obstacles, follow option B instead of option A.
Option A
, Driving the trolley off the monorail:
-
Try to push the hoist trolley unit to the end of the monorail.
-
Use a double sling chain of sufficient capacity when lifting the hoist trolley unit.
-
Lift the hoist trolley unit off the end of the monorail.
Option B
, Demount and lift the trolley off the monorail:
-
Ensure that all parts of the hoist trolley unit are supported while disassembling.
-
If applicable, open the safety latch of the top hook and lift the hoist down.
-
Loosen on one side of the trolley the support and suspension bolts.
-
Unscrew the support and suspension bolts on the other side of the trolley and
take off the hexagon lock nut and washers.
-
Slide off the side plate.
-
Lift the trolley half containing the support and suspension bolts off the monorail.
Disposal
An hoist trolley unit and its components contain a range of materials which must be disposed or
recycled, in according with statutory legislation and environmental regulations.
Please note that the following materials might have been used:
-
Ferrous materials
-
Non-ferrous materials
-
Plastics
-
Oils and greases
(Steel, Cast iron)
(Bronze, Aluminium, Copper)
(Rubber, Cabling, Component housings)
Summary of Contents for PKB Series
Page 44: ...44 10 ton N100 16 ton N160 44 ...
Page 45: ...45 20 ton N200 25 ton N250 45 ...
