2
Chapter 2
Preparations & Installation
Physical Installation Requirement
This chapter illustrates basic installation of Wi-Fi Phone
Administration Interface
PLANET Wi-Fi Phone only provides LCD keypad for machine management and administration.
Inserting the Battery
Before you can use the WiFi Phone, you have to insert the battery into the phone. Note that if you are
using the phone for the first time, the battery needs to be fully charged.
To insert the battery, carry out the following steps:
1. To open the phone, slide the phone cover towards the bottom of the phone.
2. Align the golden contacts of the battery with the corresponding connectors on the phone, and
push the opposite end of the battery until it snaps into place.
3. Close the phone cover by sliding it towards the top of the phone.
4. Press the red Power Key to turn on the phone.
Charging the Battery
On First Use:
1. Insert the battery, press the red Power Key and turn on the phone.
2. Connect the power cord to the USB slot located at the base of the phone.
3. Connect the charger to an AC wall outlet.
4. The battery can be fully charged within
3~4
hours. Then disconnect the charger first from the
phone and the AC outlet.
L
Hint
If you are using the phone for the first time, the battery
needs to be fully charged before use.
On Subsequent Use:
On subsequent use, if the power level of the battery is low, the following orange text may be displayed
at boot up:
Low Battery….
17
