Planet FGSW-1820RS, User Manual

Page: 12 / 38

8
front of the Switch.
B. Connect the other end of the cable to the network devices such as printer serv-
ers, workstations or routers…etc.

Note:
Connection to the Switch requires UTP Category 5 network cabling
with RJ-45 tips. For more information, please see the Cabling
Specification in Appendix A.
Step5: Supply power to the Switch.
A. Connect one end of the power cable to the Switch.
B. Connect the power plug of the power cable to a standard wall outlet then power
on the Switch.
When the Switch receives power, the Power LED should remain solid Green.
2.2.2 Rack Mounting
To install the Switch in a 19-inch standard rack, follow the instructions described below.
Step1: Place your Switch on a hard flat surface, with the front panel positioned towards
your front side.
Step2: Attach a rack-mount bracket to each side of the Switch with supplied screws
attached to the package. Figure 2-4 shows how to attach brackets to one side of
the Switch.
Figure 2-4 Attaching the brackets to the Switch
Caution:
You must use the screws supplied with the mounting brackets.
Damage caused to the parts by using incorrect screws would in-
validate your warranty.
Step3: Secure the brackets tightly.
Step4: Follow the same steps to attach the second bracket to the opposite side.
Step5: After the brackets are attached to the Switch, use suitable screws to securely
attach the brackets to the rack, as shown in figure 2-5.