Replacing the Hard Disk Drive
Figure 11
Removing the existing hard disk
1. Remove the back housing as above.
2. Locate the hard disk under the T-Bar.
3. Remove the four screws that secure the hard disk bracket to the main board.
4. Gently slide the hard disk back toward the top of the Clean Screen to detach it from its
connector.
5. Lift and remove the hard disk.
Installing the new hard disk
1. Remove the screws holding the adapter bracket to the old hard disk.
2. Remove the adapter bracket.
3. Attach the adapter bracket to the new 2.5" hard disk.
4. Gently slide the hard disk under the T-Bar and into its connector.
5. Replace the screws that secure the bracket to the main board.
Chapter Three: Hardware Installation and Replacement
9
2.5" Hard Disk
2.5" Hard Disk
(T10) 4-42 x
1
⁄
2
(4) screws
securing the adapter bracket to
the mother board
(T10) 4-42 x
1
⁄
2
(4) screws
attaching the adapter bracket
to the hard disk
CS Manual LAYOUT#1787 3/9/98 5:33 PM Page 9
