Manual
Version
Page
DB04A
EN A1-9
PKP Prozessmesstechnik
30
4.11.4. Gas selection
The
DB04A
can store up to 3 different curves for different gases or gas
mixtures in its memory. If you have ordered more than one gas when you
purchased this unit, you can select the required gas here. The locations
that do not have a gas programmed are marked with “N/A”.
Behind the gas name you see the maximum flow you can measure in
your selected units.
4.11.5. Settings
In this menu you can adjust your preferences. See section
4.12 Settings
for
details.
4.11.6. Info
Info brings you to menu that informs you about the current configuration of the unit. When you
select “Software” under the Info menu you can see the current firmware version and the date that
this version was released.
Under “Configuration” you see the active settings for the flow and the totalizer. The temperature
and pressure refer to the reference conditions for the selected flow units. (See
1.15 Real,
Standardized and Normalized flow
)
4.11.7. Reboot or Power off
If your unit is battery powered, it will give the option “Power off” in the main
menu. You can switch the unit on again by touching the display for 3
seconds.
If the unit is externally powered it will give you the option to “Reboot” the
unit. “Reboot” restarts the unit. If you select one of these options the unit will ask you to confirm
your selection.
> Units
> Filter
> Display
> Security
Factory reset
> Battery auto off
> Resolution
