74
28.3 Memory Card
Parameters and cycle data can be easily and quickly copied from
one controller to other controllers using the Memory Card.
The
controller must be switched off before entering the Card
.
Please
check also entry direction
: the small scanning must be
turned towards the back panel and the small IC must be turned
towards the external side of the box. When the controller is
switched-on, the green display shows
and the red display
shows
22
.
Press
Display
Do
1
visualize
,
visualize
.
Select
to load
values of memory card
on the controller.
Select
to keep
values of the controller
unchanged.
2
The controller loads the
values and starts the self-
check
To update values of Memory
Card
, follow the above described
operations selecting
on red
display
so that values of Card are not
loaded on the controller
23
.
Enter
configuration mode and
modify at
least one parameter
. Quitting the
configuration mode, a beep of internal
buzzer will confirm that the new
values are saved.
22
Only if values stored on Memory are correct
23
If the controller shows
at starting, it means that no values are
stored on memory, but it is possible to copy and update them