Pixsys ATR 142 Series, User Manual

Page: 28 / 128

28 ATR 142 - User manual
8.2
Dual Timer
This option enables two Timers and the time is selectable by
the operator: timers
cannot be started at same time .
To achieve this operation set parameter 63 as follows:
•
d. tm .s.
(Double Timer Seconds) time-basis in seconds (mm.ss)
•
d. tm. m.
(Double Timer Minutes) time-basis in minutes (hh.mm)
Check the table below for the Start procedure:
Press Effect Do
1
FNC
Press until
tim. 1
or
tim.
2
visualized on display 1.
2
Start the Timer. Display 2
shows decrementing time
and Led
R
switches on
(fixed for timer 1, flashing
for timer 2).
Back to point 1, after
selection of running Timer
press to stop counting.
Led
R
switches off.
At elapsing of Timer the led
R
switches off and display
2 flashes, showing the programmed time until any key is
pressed. Start/Stop of Timer by digital input
is NOT available
for Dual Timer mode.
8.3
Dual Sequential Timer
This option enables two Timers and the time is selectable by
the operator. At elapsing of Timer 1, counting of Timer 2 will
automatically start . At elapsing of Timer 2, counting will stop.
To achieve operation of dual sequential Timer set the parame-
ter 63
tmr.f. as follows:
•
d.s. t.s.
(Double Sequential Timer Seconds) time-basis in
seconds (mm.ss)
•
d.s. t. m.
(Double Sequential Timer Minutes) time-basis in
minutes (hh.mm)