Pixsys ATR 142 Series, User Manual

Page: 22 / 128

22 ATR 142 - User manual
For the calibration procedure refer to the following table:
Press Eff ect Do
1
FNC
Exit parameters
confi guration. Display 2
shows the writing
Latc.
Place the sensor on the
minimum operating
position (associated with
Lo.L.i.
)
2
Set the value to
minimum.
The display shows
Low
Place the sensor on the
maximum operating
position
(associated with
up.L.i.
)
3
Set the value to
maximum.
The display shows
HiGt
To exit standard
procedure press
FNC
.
For “virtual zero”
settings place the sensor
on zero point.
4
SET
Set the virtual zero
value. The display shows
uirt. NB : for selection
of u.0in. the procedure
on point 4 should
be followed at each
re-activation.
To exit the procedure
press
FNC
.
Max
Min Zero