19
4.1 CONFIGURE YOUR VIDEO SOURCE
Even if your standard definition video source has the option to output progressive video (denoted by a number
and then the letter ‘p’, for example 480p), for maximum results, it is recommended to disable such an option
and select
interlaced video mode
instead (denoted by a number and then the letter ‘i’, for example 480i).
Crystalio II
features state-of-the-art technology specifically designed to convert interlaced video into progressive
video. This will usually deliver higher performance than the converter built into your source device.
Similarly, your high definition source may have an option to scale the incoming signal to a fixed output
resolution. Again, it is advisable to turn this feature off as the sophisticated scaling algorithms in
Crystalio II
will produce far cleaner results.
4.2 SWITCH ON CRYSTALIO II
Press the
POWER
button on the front panel. The
Power LED
should show green and the
LCD display
illuminates. Note that you will need to wait for approximately 15 seconds for
Crystalio II
to initialize and for
video to display.
If you do not see video as expected, refer to
Section
8
: Troubleshooting.
The default video output of
Crystalio II
is 720p. Most high definition displays can lock to 720p
which should then enable you to use the OSD to correctly configure
Crystalio II
.
4.3 SELECT INPUT VIDEO SOURCE
Using the remote control
Press the
Menu
remote control key to enter the OSD menu, then select
Input Select
in the
Input
sub-menu.
Select the type of input port via which your input device has been connected and press
OK
to confirm.
OR
Press the
Input
remote control key and a mini menu selection list pops up. Select the type of input port
via which your input device has been connected and press
OK
to confirm.
OR
Using the front panel control
1 Press
OK
button to start Main Menu
2 Select
Input
and choose
Input Select
3 Choose input port via which your input device is connected
4 Press
OK
button to confirm
OR
Press the
INPUT
front panel button to cycle through the various input terminals and stop at the one
through which your input device is connected.
4.4 SELECT PRIMARY OUTPUT PORT
Using the remote control
Press the
Menu
remote control key to enter the OSD menu, then select
Output Select
in the
Output
sub-menu.
Select the output terminal via which your display device has been connected and press
OK
to confirm.
OR
Press the
Output
remote control key and a mini menu selection list pops up. Select the output terminal via
which your display device has been connected and press
OK
to confirm.
4. BASIC SETUP
