Setting the Transmitter
Slide the Power Switch to ON, and the device is on and Status Indicator Lamp will not
blink.
Note: In order to avoid power consumption, turn off the transmitter when not in use.
Power Switch
Slide the power switch to ON, and the AF lighting is allowed to output.
When the camera cannot focus, the AF assist beam will turn on; when the camera can
focus, the AF assist beam will turn off.
Power Switch of AF Assist Beam
Channel Settings
1. Short press the <CH
/
OK> Button until the
channel amount blinks.
2. Turn the Select Dial to choose the
appropriate channel. Press the <CH
/
OK>
Button again to confirm the setting.
3. This flash trigger contains 32 channels which
can be changed from 1 to 32. Set the
transmitter and the receiver to the same
channel before usage.
CH
-
10
-
-
09
-
Setting the Transmitter
Mode Settings
1. Short press the <GR> Button and the
selected group will blink. Click to choose
downwardly and double-click to choose
upwardly.
2. Short press the <MODE> Button and the
selected groups' modes will be changed by
the order of TTL/M/--(-- represents OFF,
which means that the current group will not
fire flashes in this mode).
Group POWER / FEC Settings
1. Short press the <GR> Button and the
selected group will blink. Click to choose
downwardly and double-click to choose
upwardly.
2. Turn the Select Dial to change the power or
flash exposure compensation settings.
When the current group is in the M mode, the
power output value is changeable from
1/1 full power to Min. [Note 1] power in 0.3 stop increments. When the current group is
in the TTL mode, the FEC amount is changeable from -3 to 3 in 0.3 stop increments.
When the current group is in the -- mode (flash off), the amounts will not change.
3. Short press the <CH
/
OK> Button again to confirm the setting.
CH
CH
