Installing Batteries
As shown in the illustration, slide the battery compartment lid of the transmitter and
receiver and insert two AA batteries (sold separately)
separately.
Low Battery Indication
When the battery power (2 AA
batteries <2.0V) gets low,
Status Indicator Lamp blinks
quickly (blink cycle=0.5s).
Please replace new batteries,
as low power leads to no flash
or flash missing in case of
long distance.
Battery
-
07
-
-
08
-
Using the Flash Trigger
Note: To set ZOOM functions, please open the ZOOM functions on the camera flash.
1. As a Wireless Flash Trigger
1.1 Mount the transmitter on camera hotshoe and turn it
on before turning on the camera.
1.2 Set the transmitter and the receiver to the same
channel by pressing Channel Setting Button.
1.3 Press the camera shutter button, and the flash will
be triggered simultaneously. Status Indicator Lamp
of transmitter turns red.
The flash trigger features the following functions:
2. As a Wireless Flash Trigger with PC Sync Socket
2.1 Set the transmitter end and receiver end to the
same channel and group.
2.2 The transmitter will control the flash on the receiver
end to fire via using PC Sync Socket as input by
default.
2.3 Press the camera shutter and use the PC Sync
Socket's signal to control the flash.
2.4 PC Sync Socket can also be set as output. Long
press the <CH
/
OK> Button of the transmitter until
<Fn> is displayed on the panel. Then, set the value
of C.Fn-03 to ou, and the PC Sync Socket is under
output mode.
