GR
CH
Setting the Receiver
Channel Setting
1. Short press the <CH> Button and the channel
amount will increase a step each time.
2. Long press the <CH> Button will enter quicker
adjustment mode. The channel amount will
increase fast in this mode.
3. Release the <CH> Button and the current channel
amount is confirmed.
4. The channel amount will increase from 1 to 32.
When the current channel is 32, press the <CH>
Button again and the channel 1 will be displayed on the panel.
GR
CH
Group Settings
1. Short press the <GR> Button and the group
amount will increase a step each time.
2. Long press the <GR> Button will enter quicker
adjustment mode. The group amount will increase
fast in this mode.
3. Release the <GR> Button and the current group
amount is confirmed.
4. The group amount will increase from A to E. When
the current group is E, press the <GR> Button
again and the group A will be displayed on the panel.
Automatically Enter Power Saving Mode
1. The system will go into standby mode after the transmitter goes into standby mode. And the
displays on the LCD panel disappear now.
2. To wake up the system, press the <TEST> Button or the <GR> Button. Fully press the
<TEST> Trigger Button of the transmitter can also wake up the receiver’s system. If the
transmitter is attached to the SONY camera, half press the camera shutter can also wake up
the system.
-
22
-
-
21
-
Attentions
1. Unable to trigger flash or camera shutter. Make sure batteries are installed correctly and
Power Switch is turned on. Check if the transmitter and the receiver are set to the same
channel, if the hotshoe mount or connection cable is well connected, or if the flash
triggers are set to the correct mode.
2. Camera shoots but does not focus. Check if the focus mode of the camera or lens is set
to MF. If so, set it to AF.
3. Signal disturbance or shooting interference. Change a different channel on the device.
4. Operating distance limited or flash missing. Check if batteries are exhausted. If so,
change them.
Caring for Flash Trigger
Avoid sudden drops.
The device may fail to work after strong shocks, impacts, or
excess stress.
Keep dry.
The product isn
'
t water-proof. Malfunction, rust, and corrosion may occur and
go beyond repair if soaked in water or exposed to high humidity.
Avoid sudden temperature changes.
Condensation happens if sudden temperature
changes such as the circumstance when taking the transceiver out of a building with
higher temperature to outside in winter. Please put the transceiver in a handbag or
plastic bag beforehand.
Keep away from strong magnetic field.
The strong static or magnetic field produced
by devices such as radio transmitters leads to malfunction.
