12
PIVOT CORPORATION
87-3, Shimookada Okada, Matsumoto-shi, Nagano, 390-0313 Japan
Check Engine
Light is ON
F
eatures
Connecting
The Wires
Installing
The Product
Ho
w to
Oper
ate
Speed Pulse
Settings
Bef
o
re
Using
T
roub
le-
Shooting
Initial
Settings
Concerning the Throttle Controller
Trouble
Possible Causes
Possible Solutions
Concerning Auto-Blipping
Trouble
Possible Causes
Possible Solutions
The “Initial Settings” have not been properly carried out.
The “Initial Settings” have not been properly carried out.
Even if the Mode is changed, the
changes cannot be felt.
Auto-Blipping will not operate.
The ignition has been tur ned to the OFF position
immediately after having finished the setting of change
ratios or changing the Mode.
After having made settings of change ratios or
changing the Mode, wait for at least 5 seconds
before turning the ignition to the OFF position.
Please reconfirm whether wiring and connections
are correct or not (See page 4 to 5 of this manual).
Please reconfirm whether wiring and connections
are correct or not (See page 4 of this manual).
The Mode and/or the setting of
change ratios can not be saved.
Make the “Initial Settings” (See page 7 of this
manual).
Make the “Initial Settings” (See page 7 of this
manual).
Make the “Speed Pulse Settings” (See page 8 of
this manual).
Make the “Initial Settings” (See page 7 of this
manual).
Please reconfirm how to operate Auto-Blipping (See
page 8 to 9 of this manual).
Please reconfirm “Auto-Blipping Settings” (See page
8 to 9 of this manual).
Please reconfirm “Auto-Blipping Settings” (See page
8 to 9 of this manual).
Press the brake pedal before operating Auto-
Blipping.
Depress the clutch pedal deeper.
May need to remove it.
The clutch adapter may have been improperly wired.
“Auto-Blipping” have not been turned on.
“Auto-Blipping Settings” have not been properly carried out.
The speed is lower than the setting value.
Clutch canceller is installed.
Have not pressed brake pedal from starting engine before
operating Auto-Blipping.
Not enough to press the Clutch pedal.
“Speed Pulse Settings” have not been properly carried out.
The “Initial Settings” have not been properly carried out.
The and wires may have been
improperly wired or there is a poor connection.
Gray
Pink
Orange
With the ignition in ON position,
Ec
o r
S P
i n d i s p l a y a n d
change to
nor
.
How to Turn Off the Check Engine Light
1. Under normal conditions, start and
stop the engine several times.
2. If that does not turn off the lamp,
disconnect the cable from minus
terminal of the battery for about 10
minutes.
3. If that does not turn off the lamp,
please consult your local car dealer
and have them turn it off.
If the Check Engine Light comes on due to some operational mistake,
please follow the directions below to turn it off.
Note
• Our products have already been recognized as our Industrial Property or are in the process of receiving Industrial Property status.
• We plan in the near future to take all possible legal measures to protect against unfair competition from look-alike products using
similar designs, regulating characteristics, circuitry and circuitry layout.
• We strictly prohibit the unlicensed use of the PIVOT trademark and the unauthorized use of PIVOT User’s Manual.
The brake lamp bulbs have been changed to LED lamp bulbs.
Replace with standard brake lamp bulbs.
(Note)
