Operator Panel
1.
Power Switch -
This is a rocker switch with indicator light. Press the top in to turn the Stacker
on. Press the bottom in to it turn off.
2.
Speed Adjustment Knob -
This speed adjustment allows the proper amount of spacing
between mail pieces so they do not overlap. Turn clockwise to increase speed and
counterclockwise to decrease speed. Using the proper speed the reduces the possibility of ink
smudging of the printed address. Refer to the Appendix to help you determine this value if
necessary.
3.
Auto/Manual Switch -
there are two modes:
l
Auto mode (switch is up) -
Stacker operation is controlled by the printer. In this mode, the
Stacker belts move when the printer is feeding mail pieces. If the printer is out of paper, has
a jam or tray break, it stops the Stacker. If the Stacker is full, the printer and Stacker both
stop. NOTE: When power is switched to the On position and Auto mode is selected, the
Stacker will not run until the printer operation begins.
l
Manual mode (switch is down) -
the Stacker runs constantly (independent of the printer).
4.
Stacker Full Light -
This LED flashes when the Stacker ramp is full, based on the setting of the
"stack full" sensor. Lift the hold down assembly to clear the material, and then lower it to resume
operation.
Stacker Controls and Indicators
Pitney Bowes
User Guide
September 2021
11
Summary of Contents for W863
