Changing the Resolution
At least 2MB of optional DRAM memory is required for 400 dpi resolution, 1.5MB of this
(approximately 110 pages) must be allocated for the printer. To change the resolution, please
repeat Steps 1 and 2, then press
6
, then
0
. Continue with Step 5 to set the resolution.
5. To enable 400 dpi printing, press
2
. Press
SET
or
…
to change from 400 dpi to 200 dpi, press
1
, then
SET
.
6. Press
STOP
. Model 9910 printer setup is complete.
4.3.1 Setting the 9920 or 9930 as a Printer
1. Press
FUNCTION
.
2. Press
9
and then
YES
.
3. Press
YES
.
4. Press
NO
.
5. Press
YES
.
6. Press
1
and then
YES
.
60 OPT. PAGE MEMORY
2: 1.5MB
SET OPTIONS?
ENTER YES OR NO
FUNCTION SELECT
ENTER FUNCTION #
PARALLEL I/F SET UP?
ENTER YES OR NO
PARALLEL I/F TYPE
1=PRINTER 2=PC
Note:
If the screen to the right appears, press
YES
to
enable the printer feature and reset the system. If you
press NO at this display, the printer feature will not be enable. If this screen doesn’t appear,
the printer is already enabled so you can press STOP. Or...you can proceed with the printer
resolution setting starting at Step 6 in the following section.
I/F SETTING CHANGE?
ENTER YES OR NO
Note
: The “Enter Passcode” prompt may not
appear. If it does, enter our Model number,
e.g., 9920 (or current Set-up Passcode) then
press
YES
to continue.
ENTER PASSCODE
_ _ _ _
AUTOMATIC REPORTS?
ENTER YES OR NO
* SETTING *
OPT MEM PAGE
65 PRINT COLLATION
2:VALID
