MGII and MG2T GAS FRYER
SERVICE
L22-236 Rev. 2 (06/11)
27
5.4.4. Tank
Removal
1. Completely drain fry tank into a suitable
container. (If changing a split tank, drain both
halves of the tank.)
2. Close Manual Gas Shut-off in gas supply
piping to fry tank being serviced.
3. Remove filter drain line, (if so equipped). See
Section 6.2.1.
4. Remove drain valve handle(s) from drain
valve(s), using 11/16” socket.
5. Unplug high limit electrical plug(s), P5, probe
electrical plug(s), P7, and drain switch
electrical plug(s), P8, from jacks above ignition
module.
6. Remove pilot assembly(s). See Section 5.3.3.
7. Loosen and disconnect gas valve(s) top flare
fitting from burner manifold, using 1-1/16” open
end wrench on female brass flare fitting at top
of valve and 15/16” open end wrench on male
brass flare fitting attached to burner manifold.
8. On filter equipped fryers, remove return valve
handle retainer(s) using 5/16” hex bit.
9. On filter equipped fryers, remove return valve
handle support bracket(s) from burner rack
using 5/16” hex bit.
WARNING! SHUT OFF APPLIANCE AND DISCONNECT ALL POWER
CONNECTIONS PRIOR TO STARTING ANY SERVICE WORK
WARNING! DISCONNECT APPLIANCE FROM GAS SUPPLY OR SHUT
MANUAL GAS VALVE PRIOR TO SERVICING GAS TRAIN
