7
EN
EN
G
LI
SH
ASSEMBLYPREPARATION
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack
after removing from the protective shipping carton. Discardall packaging materials from inside and outside of the grill before
assembly,then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to
assemble.Shipping damage is not covered under warranty. Contact your dealer or Pit Boss®CustomerServicefor parts: Monday
through Sunday, 4am - 8pm PST(EN/FR/ES).
[email protected] | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary)when assembling this unit.
Tools required for assembly:
screwdriver and level.
Tools not included.
ASSEMBLYINSTRUCTIONS
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screwsfor that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closestto the head of the screw.
1. MOUNTING THE LEGSTOTHE MAIN BARREL
Parts Required:
1
x
Main Barrel /Hopper Assembly (#12)
1
x
Left Support Leg - Front (#22)
1
x
Left Support Leg - Back (#23)
1
x
Right Support Leg / Front (#24)
1
x
Right Support Leg / Back (#25)
12 x
Screw (#A)
12 x
Washer (#B)
12 x
Locking Washer (#C)
Installation:
•
Placeapieceof cardboardon the floor to prevent scratching the unit and
parts during assembly.Lay the Main Barrel on its side on the cardboard,
hopper end pointed upward.
•
Mount the Front-Right Support Leg to the floor end of the Main Barrel
using three screws,locking washers,and washers,through the three pre-
drilled holes. Install screws from the inside of the Main Barrel. Repeat
installation for Back-Right Support Leg.Note illustration 1A.
•
Next, mount the Front-Left Support Leg to the hopper end of the Main
Barrel using three screws, locking washers, and washers, through the
three pre-drilled holes.Install screwsfrom the inside of the Main Barrel.
Repeat installation for Back-Left Support Leg.Note illustration 1B.
IMPORTANT:Do not tighten screwscompletely until bottom shelf is
installed in next step.
1A
1B
25
24
22
23
BCA
BCA
BC
A
BC
A
