No Diving or Jumping. Observe all Safety Rules
Section
3
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
1. Preparing for the wall installation
a. Bring the following items into the middle of the pool
foundation before you start uncoiling the pool wall:
plywood, some extra sand or fine dirt to make the cove
and a ladder to climb out after the wall is assembled.
b. Make sure the skimmer and water return holes are
located where you need them to be. The skimmer and
water return holes are positioned towards the end of the
wall,
(the section before where the wall started).
2. Set the pool wall in place.
a. Unpackage the coiled pool wall and stand it on the
plywood at the place close to where you need to install
the skimmer.
(Image 1)
(Remember the skimmer and water return holes will
be placed at the section just before where you started
the wall installation).
b. Start uncoiling the wall, guiding the bottom edge into
the curved bottom rail. The starting end of the wall must
be positioned in the centre of a bottom plate, and the
skimmer and return holes should be positioned where the
pump and filter will be.
(Images 2 to 4)
NOTE: It is important that the pool wall be evenly distributed
at both ends of the pool to ensure that all the top rails fit.
As the wall is uncoiled and placed into the bottom rails it
is important to maintain approximately 1/2" (13mm) gap
between the bottom rails or the top rails may not fit.
A. SETTING UP THE POOL WALL
Do not attempt to install the pool wall in the wind, wait for a calm day.
It takes at least 3 people to install the pool wall.
1
2
Important Note:
Secure the omega stabilizer to the wall with a piece of duct
tape after installation to prevent it from lifting off the wall.
3-1
3
4
Important Note:
It is preferable to use very fine sand that is easily compacted.
Be careful not to spill sand on the bottom rails. Be sure to
clear sand or stone dust from the bottom rails otherwise the
wall will buckle.
