No Diving or Jumping. Observe all Safety Rules
Section
3
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
A. CONT. SETTING UP THE POOL WALL
3. Installation of the wall
a. Continue installing the wall around the foundation until
the entire pool wall is uncoiled into the bottom rails and
the top edge is covered with the omega stabilizer and
connectors (and beaded liner retainers if you have a
beaded pool liner).
NOTE:
We also suggest installing vinyl-covered hooks
and rope to hold the wall steady.
(Image 6)
b. After the wall is installed, go around the entire pool and
make sure all the gaps between the bottom rails are
equal in size (the gaps may each finish slightly smaller
or larger than 1/2” (13 mm), check footprint for gap
measurement). Recheck all of the bottom plates to make
sure each one is centred between the bottom rails.
c. After the pool wall has been installed, reconfirm
distances to the base plates. Make sure the pool is
perfectly round.
5. Make sure the pool wall is round
a. Using a tape measure, measure across the circle at each
bottom plate. The pool wall must be round. Adjust the
circle by nudging the bottom plates in or out with your
foot.
(Image 7)
6
3-2
7
