Piper Arrow IV, Maintenance Manual

Page: 462 / 752

(4) A good deal of oxygen will remain in the large cylinders used in the cascade system after
filling only one of the cylinders but such remaining oxygen will be a pressure something less
than the 1850 psi which is not sufficient pressure to completely refill another aircraft cylinder
although it will refill several smaller cylinders.
(5) It is not economical even on a three or four cylinder cascade system to begin recharging with
oxygen at less than 300 psi pressure in the 300 cubic foot bank of cylinders. So use 300 cubic
foot cylinders down to approximately 300 psi; then return for refilling. In two cylinder
systems use to approximately 100 psi; then return for filling.
D. When the pressure gauge on the recharge unit or in the aircraft reaches 1800 to 1850 psi., close the
pressure regulator valve on the recharge unit. Disconnect the filler hose from the filler valve;
replace the protective cap on the filler valve and close the access cover. (Check the cylinder
pressure according to Chart 3503 after the cylinder temperature stabilizes.
5. After detaching the service cart, cap hose and fittings to prevent contamination.
6. Perform a leak check of the high pressure lines and clean off solution afterwards. If solution is not
properly cleaned off, unusual corrosion may result.
PORTABLE. - OXYGEN SYSTEM. (Refer to Figure 35-2.)
Due to the nature of the process used to test compressed gas tanks, it is recommended that overhaul,
service, or hydrostatic tests be conducted by an FAA DOT, or manufacturer (Scott Aviation) approved shop.
The following material gives recommended inspection and maintenance information for the various parts of
the oxygen system.
—NOTE—
Oxygen cylinders are identified by the ICC or DOT identification
stamped on the cylinder. The standard weight cylinder (3AA
1800) must be hydrostatically tested at the end of every five years.
Light weight cylinders (3HT 1850) must be tested every 3 years
and be replaced after 4380 refills or 24 years whichever comes
first. The month and year of the last test is stamped on the
cylinder beneath the identification.
1. Inspect outlets, and test for leaks in the “use” and “non-use” condition. Refer to next subject
paragraph.
2. Check pressure gauge for accuracy by removing the back section of the unit and connecting gauge of
known accuracy to the fill port.
3. Inspect tank for dents, bulges, major strap chafing marks or corrosion. Should any of these conditions
exist, the tank should be hydrostatical1y tested.
TESTING FOR LEAKS.
Apply detector fluid Leak-Tec Formula #16-OX (see Chart 9101) or an equivalent. The solution should be
shaken to obtain suds or foam. The solution should be applied sparingly to the joints of the system while
looking for traces of bubbles. Visible leaks are not allowed and any defective parts replaced or repaired. The
system should be further observed for leaks when fully pressurized. All traces of detector fluid should be
wiped off at the conclusion of the examination.
35-10-18
Page 35-17
Added: November 6, 1979
2H15
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL