Pioneer X-HM10-K, Operating Instructions Manual

Page: 9 / 184

Downloaded from www.vandenborre.be
11/5/25 X-HM10_20_En.fm
9
8
7
6
5
4
3
2
1
En-9
General control
Press the STANDBY/ON button to turn the power on.
To dim the display brightness, press the DIMMER button on the
remote control.
If you turn off and on the main unit with the volume set to 17 or higher,
the volume starts at 16.
Turn the volume knob towards VOLUME (on main unit) or press VOL
+/– (on remote control) to increase or decrease the volume.
When you press any of the following buttons, the unit turns on.
l
iPod / iPhone, CD, USB, LINE, TUNER on the remote control:
Selected function is activated.
l
/ button on the main unit: The unit turns on and playback of
the last function will start (CD, TUNER, USB, iPod, LINE IN)
The main unit will enter the stand-by mode (when iPod/iPhone is not
docked) after 15 minutes of inactivity during:
iPod/iPhone: No connection.
CD / USB: In the stop mode.
LINE IN:No detection of input signal or very low sound au-
dibility.
Note:
X-HM20 only: However, if iPod/iPhone is docked, the unit will begin
charging.
“Charge Mode” will be displayed during standby mode.
The volume is muted temporarily when pressing the MUTE button on
the remote control. Press again to restore the volume.
When the power is first turned on, the unit will enter the P.bass mode
which emphasises the bass frequencies. To cancel the P.bass mode,
press the P.BASS button on the remote control.
1
Press the BASS/TREBLE button to select “Bass”.
2
Within 5 seconds, press the VOL (+ or –) button to adjust the
bass.
1
Press the BASS/TREBLE button to select “Treble”.
2
Within 5 seconds, press the VOL (+ or –) button to adjust the
treble.
When the INPUT button on main unit is pressed, the
current function will change to different mode. Press the
INPUT button repeatedly to select desired function.
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or the
AC power lead becomes disconnected.
Setting the clock (Remote control
only)
In this example, the clock is set for the 24-hour (00:00) display.
n
To turn the power on
After use:
Press the STANDBY/ON button to enter the power stand-by mode.
n
Display brightness control
n
Volume auto set-in
n
Volume control
n
Auto power on function
n
Auto power off function
n
Muting
P.BASS
VOL VOL
STANDBY/ON
MUTE
VOLUME
DIMMER
BASS/TREBLE
INPUT
STANDBY/ON
Dimmer 1
Dimmer 2
Dimmer Off
(Display is dim).
(Display gets dimmer).
(Display is bright).
n
P.Bass control
n
Bass control
n
Treble control
n
Function
1
Press the STANDBY/ON button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the ENTER button. To adjust the day,
press the or button and then press the ENTER button.
-5 -4 +4 +5
........
-5 -4 +4 +5
........
FM STEREO
FM MONO
USB iPod
Line In
CD AM
(X-HM20 only)
STANDBY/ON
TUNING − TUNING ＋
CLOCK/TIMER
ENTER