Additional information
13
90
En
Important information regarding the HDMI
connection
There are cases where you may not be able to route HDMI
signals through this receiver (this depends on the HDMI-
equipped component you are connecting–check with the
manufacturer for HDMI compatibility information).
If you aren’t receiving HDMI signals properly through this
receiver (from your component), please try one of the
following configurations when connecting up.
Configuration A
Use component video cables to connect the video output
of your HDMI-equipped component to the receiver’s
component video input. The receiver can then convert the
analog component video signal to a digital HDMI signal
for transmission to the display. For this configuration,
use the most convenient connection (digital is
recommended) for sending audio to the receiver. See the
operating instructions for more on audio connections.
Note
• The picture quality will change slightly during
conversion.
Configuration B
Connect your HDMI-equipped component directly to the
display using an HDMI cable. Then use the most
convenient connection (digital is recommended) for
sending audio to the receiver. See the operating
instructions for more on audio connections. Set the
display volume to minimum when using this
configuration.
Note
• If your display only has one HDMI terminal, you can
only receive HDMI video from the connected
component.
• Depending on the component, audio output may be
limited to the number of channels available from the
connected display unit (for example audio output is
reduced to 2 channels for a monitor with stereo audio
limitations).
• If you want to switch the input source, you’ll have to
switch functions on both the receiver and your
display unit.
• Since the sound is muted on the display when using
the HDMI connection, you must adjust the volume on
the display every time you switch input sources.
XM radio messages
Symptom
Cause
Action
Check XM Tuner
The XM Mini-Tuner is not installed or not fully seated
in the XM Mini-Tuner Dock or the XM Mini-Tuner
dock is not connected to this receiver.
Confirm the XM Mini-Tuner is fully seated in the dock
and check the XM Mini-Tuner dock cable is
connected to this receiver.
Check Antenna
The XM antenna is not connected to the XM Mini-
Tuner Dock or the XM antenna cable is damaged.
Check that the XM antenna is securely connected to
the XM Mini-Tuner Dock and check the antenna
cable for damage. Replace the XM antenna if the
cable is damaged.
Loading
The XM Mini-Tuner is acquiring audio or program
information from the XM satellite signal. This
message can also occur in weak XM signal
conditions.
Note that this receiver may not respond to some
buttons while this message is displayed.
This message should disappear in a few seconds in
good signal conditions.
If you see this message often, reposition the XM
antenna for better signal reception.
Use the Antenna Aiming option to optimize the
antenna position.
No Signal
The XM Mini-Tuner is not receiving the XM satellite
signal. Something may be blocking the XM
antenna’s view of the satellites or the antenna is not
properly aimed.
Check for antenna obstructions and reposition the
XM antenna to get better signal reception. Use the
Antenna Aiming option to optimize the antenna
position.
See instructions supplied with the XM Mini-Tuner
and Dock for antenna installation information.
Off Air
You selected an XM channel that is not currently
broadcasting.
Check back later; in the mean time, select another
channel.
CH Unauthorized
You selected an XM channel that is blocked or
cannot be receive with your XM subscription
package.
Consult the latest channel guide at
www.xmradio.com for the current list of channels.
For information on receiving this channel, visit
www.xmradio.com or contact XM Satellite Radio at
1-800-967-2346.
VSX-03TXH_KU.book 90 ページ ２００８年４月１６日 水曜日 午後１時１９分
