1
Use MULTI-CONTROL to select
Warning tone.
2
Press MULTI-CONTROL to turn warning
tone on.
#
To turn warning tone off, press
MULTI-CONTROL
again.
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to
Using
the AUX source
on page 28.
1
Use MULTI-CONTROL to select AUX1/
AUX2.
2
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
’
s headlights are turned on. You
can turn the dimmer on or off.
1
Use MULTI-CONTROL to select Dimmer.
2
Press MULTI-CONTROL to turn dimmer
on.
#
To turn dimmer off, press
MULTI-CONTROL
again.
Adjusting the brightness
You can adjust the display brightness. Initially
this mode is set to
12
.
1
Use MULTI-CONTROL to select
Brightness.
2
Push MULTI-CONTROL left or right to
adjust the brightness level.
0
to
15
is displayed as the level is increased or
decreased.
#
When dimmer is functioning, the brightness
level can be adjusted
0
to
10
.
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Rear SP :F.Range
) or subwoo-
fer (
Rear SP :S/W
) connection. If you switch
the rear output setting to
Rear SP :S/W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
Rear SP :F.Range
).
1
Use MULTI-CONTROL to select
S/W control.
2
Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL
will switch be-
tween
Rear SP :F.Range
(full-range speaker)
and
Rear SP :S/W
(subwoofer) and that status
will be displayed.
#
When no subwoofer is connected to the rear
output, select
Rear SP :F.Range
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
Rear SP :S/W
.
Notes
!
Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
Using subwoofer output
on page
23).
!
If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
!
Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.
Operating this unit
En
26
Section
02
