INSTALLATION AND ASSEMBLY
36
[Fig. 3-2-2]
4
RM-V2550S unpacking procedure [Fig. 3-2-2]
NOTE) 1. After removing the top cover protecting the screen surface, be specially careful not to damage or
stain it.
NOTE) 2. The accessories are attached on the under-carton.
NOTE) 3. With the RM-V2550S2, there are no urethane pads B and C or black tape.
[1] Remove the top cover.
[2] Peel off the pieces of tape attached to urethane pads B (x 2) and urethane pads C (x 2) by cutting them using
a cutting knife from outside the under-carton, and remove urethane pads B (x 2) and urethane pads C (x 2).
[3] Peel of the piece of tape from the mirror mat, remove the screen unit and place it standing on a level surface.
[4] Fold the mirror mat which has been wrapped around the screen kit into two, place the folded mat on a level
surface and lay down the screen kit on it paying attention not to apply impact.
[5] Gently peel off the pieces of black tape attached on the four edges of the screen, then peel of the pieces of
black tape attached on the two ends of the right side.
* Peel off slowly and cautiously so as not to damage the reticular sheet.
[6] Remove the 8 transport screws (black) and 4 protection panels.
* The protective panels are attached using transport screws. Retain the removed panels if you expect to
need them in the future. When installing the system, do not remove the screen kit protection panel at the
outmost location.
The shorter protective panels are necessary for use in connecting the left and right of the topmost screen
kit when installing the system. For details, please read the system assembly procedure.
[7] When unpacking the multiple kits first, store them in a separate location to prevent damage and cover them
with a sheet to protect them from dust.
[1]
[2]
[3]
[4] [5] [6]
Top cover
Urethane pads C
Urethane pads B
White sheet
Black tape
Top edge
Right side edge
Protective panels
Transport screws (x 8, black)
Black tape
Black tape
Level surface
Protective panels
Top
Accessory parts
Summary of Contents for RMD-V3104U
