Pioneer RMD-V3104U, Manual

Page: 153 / 201

143
ADJUSTMENTS
4 Precautions upon use (Adjustment control unit)
• Always release the adjustment mode with
ADJ OUT
button and turn off the power with the
POWER
button
after adjustments and settings. All adjusted values and settings will be memorized.
• The remote control adjustment mode will automatically be exited in the following.
1. When no operations are performed for about 180 seconds.
2. When the rear panel switch is pressed
3. When the power is turned off
4. When the input signal is switched, the cable is disconnected, or the mode is switched : NTSC PAL.
(However, in some cases, switching between PAL and no-signal may not exit the mode.)
• One MPJ cannot be adjusted using the remote control unit and personal computer simultaneously. If using
the remote control unit after the personal computer adjustment mode has been started up, start up the re-
mote control unit adjustment mode or turn off the power once.
• When operating several MPJ simultaneously, do not press the buttons quickly and continuously as some
MPJ may not synchronize with the other MPJ.
• MPJ not assigned an ID cannot be operated using the remote control unit. To exit this state, perform one of
the following.
1. Start up the remote control adjustment mode using the
ADJ IN
button.
2. Exit the remote control adjustment mode using the
ADJ OUT
button.
3. Turn off the power.
• The remote control signal is output to the next MPJ via the link terminal only when a certain ID is set to the
MPJ. When operating several MPJ, set this ID to all the MPJ. Only MPJ connected with the link cable located
after the MPJ to which the remote control unit is connected can be operated.
• Handle the wire carefully.
7
Using dry batteries incorrectly will result in battery liquid leakage, damage, etc. Take note of the follow-
ing. (Also refer to precautions provided for dry batteries.)
• Load the
ª
and
·
sides of the batteries correctly as shown on the battery case.
• Do not use old and new batteries together.
• Batteries of the same shape may have different voltages.
Do not use different batteries together.
• When not using the unit for a long period of time (one month), remove the batteries to prevent battery
liquid leakage.
If leakage occurs, wipe the liquid thoroughly and load new batteries.
• Do not charge, short-circuit, disassemble, nor throw into fire the dry batteries provided.
Warning for Use of Dry Batteries