137
Menu Mode
2) Setting POWER MANAGEMENT and AUTO POWER ON/OFF
To save electricity, this function automatically shifts the device into power-saving mode when no picture (sync)
signal is detected.
• If not using this power-saving function
→
select OFF.
• To enter power standby if no input signal is detected after 8 min
→
select AUTO POWER OFF: ON.
• To switch between routine operating status and power-saving status, in accordance with the presence of signals
→
Select POWER MANAGEMENT: ON.
Set-able condition
: POWER MANAGEMENT: INPUT 1 (personal computer signal), INPUT5
★
(applies only
when equipped with PDA-5002)
AUTO POWER OFF; other than the above
Factory preset
: OFF
1
Select SET UP.
Screen
1
2
Move the cursor to POWER MANAGEMENT
(AUTO POWER OFF) and use the SET button to
change the setting.
Setting will change between OFF and ON each
time the SET button is pressed.
Screen
2
SELECT
CHANGE
EXIT
SET
MENU
PICTURE
SCREEN
SET UP
OPTION
: A U T O
S E T T I N
C L AMP
POWE R
:
G
OF F
P
S I T I O N
O
M N A GEME
A
I N P UT
I N P UT 1
L
E
B
L A
: V G A
:
NT
MAIN MENU
INPUT1
SELECT
ENTER
EXIT
SET
MENU
PICTURE
SCREEN
SET UP
OPTION
: V G A
:
NT
: A U T O
S E T T I N
C L AMP
POWE R
:
G
OF F
P
S I T I O N
O
M N A GEME
A
I N P UT
I N P UT 1
L
E
B
L A
MAIN MENU
INPUT1
(NOTE)
• To restore routine operating status from power standby status, press the POWER button on the remote control or
main unití-s operation panel.
• To restore routine operating status from power-saving status, either use a personal computer or press the INPUT
button on the remote control or main units operation panel.
However, when there is G ON SYNC or composite SYNC input, it will not be possible to restore routine operating
status via personal computer alone. The INPUT button will need to be pressed after the personal computer has
been operated appropriately.
• Power consumption in power standby mode will be 1W.
• Power consumption in power-saving mode will be around 1W for INPUT 1 and around 50W for INPUT 5.