Before you start
01
5
En
English
Français
Español
Chapter 1:
Before you start
What’s in the box
Please confirm that the following accessories are in the
box when you open it.
• Remote Control
• Power cord
• RCA audio cable (red/white plugs)
• AAA batteries (R03) x 2
• Operating instructions (this document)
Loading the batteries in the remote
control
1
Open the rear lid and load the batteries
as illustrated below.
2
Close the rear lid.
The batteries included with the unit have been provided
to allow you check product operation and may not last
long. We recommend using alkaline batteries that have
a longer life.
Caution
• When inserting the batteries, make sure not to
damage the springs on the battery’s
terminals.
• Do not use any batteries other than the ones
specified. Also, do not use a new battery together
with an old one.
• When loading the batteries into the remote control,
set them in the proper direction, as indicated by the
polarity marks (
and
).
• Do not heat batteries, disassemble them, or throw
them into flames or water.
• Batteries may have different voltages, even if they
are the same size and shape. Do not use different
types of batteries together.
• To prevent leakage of battery fluid, remove the
batteries if you do not plan to use the remote
control for a long period of time (1 month or more).
If the fluid should leak, wipe it carefully off the
inside of the case, then insert new batteries. If a
battery should leak and the fluid should get on your
skin, flush it off with large quantities of water.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public institution’s rules that apply in your country/
area.
•
WARNING
Do not use or store batteries in direct sunlight or
other excessively hot place, such as inside a car or
near a heater. This can cause batteries to leak,
overheat, explode or catch fire. It can also reduce
the life or performance of batteries.
Using the remote control
The remote has a range of about 7 m (23 ft.) at an angle
of about 30º from the remote sensor.
/I STANDBY/ON
STANDBY
iPod/USB
5V
2.1A
PURE AUDIO
Hi-Bit32
30°
30°
7 m (23 ft.)
Keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the
remote and the remote sensor on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the unit’s
remote sensor.
• Remote controllers for different devices can
interfere with each other. Avoid using remotes for
other equipment located close to this unit.
• Replace the batteries when you notice a fall off in
the operating range of the remote.
Remote operation on an iPod touch/
iPhone/iPad
• Operation via LAN is possible from an iPod touch,
iPhone or iPad by downloading a Pioneer original
application from the iTunes Store.
This special application may be changed or
discontinued without notice.
N-50-K_En.book 5 ページ ２０１１年９月７日 水曜日 午後５時４分
