Setting the TV signal
When this unit is connected to a TV tuner, you
need to adjust the TV signal suitable to your
country TV signal setting.
!
About your country TV signal, consult with
your nearest Pioneer dealer.
1
Use MULTI-CONTROL to select
TV SIGNAL.
Refer to
Adjusting initial settings
on page 51.
2
Press MULTI-CONTROL to select an ap-
propriate TV signal.
PAL
—
SECAM
Correcting distorted sound
Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to
LOW
. Normally, leave the set-
ting at
HIGH
to ensure quality sound.
1
Use MULTI-CONTROL to select D.ATT.
Refer to
Adjusting initial settings
on page 51.
2
Press MULTI-CONTROL to switch the di-
gital attenuator setting.
!
HIGH
–
High quality sound
!
LOW
–
Minimize distortion sound
Resetting the audio functions
Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can reset audio functions other than the
following settings.
!
Volume setting (refer to
Adjusting the vo-
lume
on page 18)
!
Listening position setting (refer to
Using
the position selector
on page 68)
!
Fader/balance setting (refer to
Using bal-
ance adjustment
on page 68)
!
SLA (source level adjustment) setting (refer
to
Adjusting source levels
on page 70)
!
Dynamic range control (refer to
Using the
dynamic range control
on page 70)
!
Direct control setting (refer to
Using the di-
rect control
on page 70)
!
Down-mix setting (refer to
Using the down-
mix function
on page 70)
1
Use MULTI-CONTROL to select
AUDIO RESET.
Refer to
Adjusting initial settings
on page 51.
2
Press MULTI-CONTROL to display OK.
#
To cancel resetting the audio functions, press
BAND
.
3
Push MULTI-CONTROL right to display
REALLY?.
#
To cancel resetting the audio functions, press
BAND
.
4
Press MULTI-CONTROL to reset audio
functions.
COMPLETE
appears in the display.
Operating this unit
En
55
Section
02
Operating
this
unit
