24
04
Section
En
Installation
Remove the Unit
1 Remove the panel (page 9).
2 Remove the trim ring by firmly grasping
one side and pulling.
3 Insert the removal keys straight back
until they lock, then pull the radio out.
If the removal keys are inserted at an
angle, they will not lock properly and will
not release the unit.
1 Remove the existing factory radio
from the dashboard or center console
mounting. Save all hardware and
brackets as they will be used to mount
the new radio.
2 Carefully unsnap the plastic frame from
the front of the new unit chassis. Remove
and discard the frame.
3 Remove the factory mounting brackets
and hardware from the existing unit
and attach them to the new unit. Do not
exceed M5 x 6mm maximum screw size.
Longer screws may damage components
inside the chassis.
4 Wire the new unit as outlined in the
Mounting Sleeve Installation instructions.
5 Mount the new unit assembly to the
dashboard or center console using the
reverse procedure of step 1.
Fuse
When replacing a fuse, make sure the new
fuse is the correct type and amperage.
Using an incorrect fuse could damage the
radio.
Reconnect battery
When wiring is complete, reconnect the
battery negative terminal.
