Black plate (58,1)
<CRD3840-A/N>58
Adjusting nonfading output level
When the nonfading output is on, you can ad-
just the level of nonfading output.
1 Use Multi-Control to select nonfading
output setting.
NonFad 0
appears in the display.
2 Push Multi-Control up or down to ad-
just the nonfading output level.
Each pushing
Multi-Control
up or down in-
creases or decreases the level of the nonfad-
ing output.
+6
6
is displayed as the level is
increased or decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
1 Use Multi-Control to select HPF.
HPF
appears in the display.
2 Press Multi-Control to turn high pass fil-
ter on.
HPF 80 Hz
appears in the display. High pass
filter is now on.
#
To turn high pass filter off, press
Multi-Control
again.
3 Push Multi-Control left or right to select
cut-off frequency.
Each pushing
Multi-Control
left or right se-
lects cut-off frequencies in the following order:
50
80
125
(Hz)
Only frequencies higher than those in the se-
lected range are outputted from the front or
rear speakers.
Note
If you switch the SFEQ setting, the HPF function
is automatically turned off. By turning the HPF
function on after selecting the SFEQ setting, you
can combine HPF function with SFEQ
function.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
!
Settings are based on the FM tuner volume
level, which remains unchanged.
1 Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2 Use Multi-Control to select SLA.
SLA
appears in the display.
3 Push Multi-Control up or down to ad-
just the source volume.
Each pushing
Multi-Control
up or down in-
creases or decreases the source volume.
SLA +4
SLA
4
is displayed as the source vo-
lume is increased or decreased.
Notes
!
The MW/LW tuner volume level can also be
adjusted with source level adjustments.
!
The built-in CD player and the multi-CD player
are set to the same source level adjustment
volume automatically.
!
External unit 1 and external unit 2 are set to
the same source level adjustment volume
automatically.
Audio Adjustments
En
58
Section
12
