Black plate (57,1)
<CRD3840-A/N>57
3 Push Multi-Control left or right to select
a desired level.
Each pushing
Multi-Control
left or right se-
lects level in the following order:
LOW
(low)
MID
(mid)
HIGH
(high)
4 To turn loudness off, press
Multi-Control again.
Loud OFF
appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1 Use Multi-Control to select Sub-W1.
Sub-W1
appears in the display.
#
When the subwoofer controller setting is
PREOUT:FULL
, you cannot select
Sub-W1
.
2 Press Multi-Control to turn subwoofer
output on.
Sub-W1 Normal
appears in the display. Sub-
woofer output is now on.
#
To turn subwoofer output off, press
Multi-Control
again.
3 Push Multi-Control left or right to select
the phase of subwoofer output.
Push
Multi-Control
left to select reverse
phase and
Rev.
appears in the display. Push
Multi-Control
right to select normal phase
and
Normal
appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use Multi-Control to select Sub-W2.
Sub-W2
appears in the display.
#
When the subwoofer output is on, you can se-
lect
Sub-W2
.
2 Push Multi-Control left or right to select
cut-off frequency.
Each pushing
Multi-Control
left or right se-
lects cut-off frequencies in the following order:
50
80
125
(Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push Multi-Control up or down to ad-
just the output level of the subwoofer.
Each pushing
Multi-Control
up or down in-
creases or decreases the level of the subwoo-
fer.
+6
6
is displayed as the level is
increased or decreased.
Using nonfading output
When the nonfading output setting is on, the
audio signal does not pass through this unit
s
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Use Multi-Control to select nonfading
output on/off setting.
NonFad ON
appears in the display.
#
When the subwoofer controller setting is only
PREOUT:FULL
, you can switch to the nonfading
output on/off setting. (Refer to page 62.)
2 Press Multi-Control to turn nonfading
output on.
NonFad ON
appears in the display. Nonfading
output is now on.
#
To turn nonfading output off, press
Multi-Control
again.
Audio Adjustments
En
57
English
Section
12
