2 Press
n
to start the test tone output.
The test tone is output. It rotates from speaker
to speaker in the following sequence at inter-
vals of about two seconds. The current set-
tings for the speaker over which you hear the
test tone are shown in the display.
Front speaker left
Center speaker
Front
speaker right
Rear speaker right
Rear
speaker left
Subwoofer
#
Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the test
tone.
#
The settings do not appear for speakers
whose size is set
OFF
.
3 Press
r
or
q
to adjust the speaker
output level.
Each press of
r
or
q
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
#
The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Press
m
to stop the test tone output.
5 Press BAND to return to the playback
display.
Notes
!
If needed, select speakers and adjust their
ab-
solute
output levels. (Refer to
Adjusting the
speaker output levels
on the previous page.)
!
To adjust the speaker output levels at this
mode is the same as making the speaker out-
put levels at
SP Lev
. Both provide the same re-
sults.
Adjusting the time alignment
By adjusting the distance between each
speaker and a selected listening position, you
can insert delay times into the speaker output
to obtain a correct sound image and overall
level balance. Although this is automatically
achieved when you set the listening position,
the time alignment feature provides a fine ad-
justment.
1 Press
p
and hold until SP Set appears
in the display, then press
p
to select
Time A.
After
SP Set
is displayed, press
p
until
Time A
appears in the display.
#
You cannot select
Time A
when neither
F/L
nor
F/R
is selected in
Posi
.
2 Press
m
or
n
to select the speaker
to be adjusted.
Each press of
m
or
n
selects the speaker
in the following order:
Front speaker left
Center speaker
Front
speaker right
Rear speaker right
Rear
speaker left
Subwoofer
#
You cannot select speakers whose size is set
OFF
.
3 Press
r
or
q
to adjust the distance
between the selected speaker and the lis-
tening position.
Each press of
r
or
q
increases or de-
creases the distance.
500.0
(cm)
0.0
(cm) is
displayed as the distance is increased or de-
creased.
4 Press BAND to return to the playback
display.
Using the equalizer
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
Digital Signal Processor
En
25
English
Section
07
