Selecting a cut-off frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SMALL
, you can select a
frequency, under which sounds are repro-
duced through a
LARGE
speaker or subwoo-
fer.
1 Press
p
and hold until SP Set appears
in the display, then press
p
to select
CutOff.
After
SP Set
is displayed, press
p
until
CutOff
appears in the display.
2 Press
m
or
n
to select cut-off fre-
quency.
Each press of
m
or
n
selects cut-off fre-
quencies in the following order:
63
80
100
125
160
200
(Hz)
3 Press BAND to return to the playback
display.
Note
Selecting a cut-off frequency is to set a cut-off fre-
quency of the subwoofer
s L.P.F. (low-pass filter)
and that of the
SMALL
speaker H.P.F. (high-pass
filter). The cut-off frequency setting has no effect
if the subwoofer is set to
OFF
and other speakers
are set to
LARGE
or
OFF
.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Press
p
and hold until SP Set appears
in the display, then press
p
to select
SP Lev.
After
SP Set
is displayed, press
p
until
SP Lev
appears in the display.
2 Press
m
or
n
to select the speaker
to be adjusted.
Each press of
m
or
n
selects the speaker
in the following order:
Front speaker left
Center speaker
Front
speaker right
Rear speaker right
Rear
speaker left
Subwoofer
#
You cannot select speakers whose size is set
OFF
.
3 Press
r
or
q
to adjust the speaker
output level.
Each press of
r
or
q
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
4 Press BAND to return to the playback
display.
Note
To adjust the speaker output levels at this mode is
the same as making the speaker output levels at
T Tone
. Both provide the same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Press
p
and hold until SP Set appears
in the display, then press
p
to select
T Tone.
After
SP Set
is displayed, press
p
until
T Tone
appears in the display.
Digital Signal Processor
En
24
Section
07
