87
AVIC-W8400NEX/XNUC
5
6
7
8
5
6
7
8
A
B
C
D
E
F
Fig.4
1
2
3
4
Remove the two screws.
Remove the two screws.
Remove the three screw.
Disconnect the connector and then remove
the Heat Sink and the Holder.
3
1
3
1
4
- Removing the
Bracket
(1/2) (Fig.4)
Heat Sink
Holder
1
2
Fig.3
- Removing the DVD Mechanism Module (Fig.3)
Remove the four screws.
Disconnect the connector and then remove
the DVD Mechanism Module.
1
1
1
1
DVD Mechanism Module
2
3
2
2
When installing DVD Mechanism Module, please
combine the bracket with DVD Mechanism
Module and tighten the screw as shown below.
Make sure that the dowel of DVD Mechanism
Module is in the slit of Bracket.
DVD Mechanism Module
Bracket
Don’t remove this screws excluding
the dismantlement of the DVD Mechanism
Module.
Attention of removing
Attention at assembly
Attention at assembly
a. Hook on the left and right hooks of the holder
b. Simultaneously push the part marked with
a circle in the direction of the arrow
c. Confirm that the dowels are engaged in
the left and right slits
*) Do not press near the red circle because
Bracket may be distorted.
c
a
b