Introduction to built-in DSP
features
Important
We recommend that you record the settings in
the sheet on page 129 after you have completed
audio adjustments.
DSP modes
This unit features two DSP modes: the net-
work mode and the standard mode. You can
switch between DSP modes as desired. Initi-
ally, the DSP mode is set to the standard
mode. (Refer to
!
Auto TA and EQ can be used for the stan-
dard mode only. (Refer to
(auto-time alignment and auto-equalizing)
on page 96 and
!
A 2-way front speaker output can be used
for the network mode only.
Note
Switching the DSP mode erases the current ad-
justing audio settings (
LAST MEMORY
). If
needed, memorize it into custom settings
(
CUSTOM1
,
CUSTOM2
or
CUSTOM3
).
Output channel modes
(
2CH/Multi CH
)
This unit has two output channel modes for
each DSP mode: the 2-channel mode and the
multi-channel mode. You can switch between
output channel modes depending on the
source that you have selected.
!
Dolby Pro Logic II/Dolby Digital EX and DTS
Neo:6 (
Dolby/DTS
) can be used for multi-
channel mode only.
!
Graphic equalizer (
GRAPHIC EQ
) can be
used for 2-channel mode only.
!
Parametric equalizer (
PARAMETRIC EQ
)
can be used for multi-channel mode only.
Note
When selecting 2-channel mode, audio does not
be output from front center and rear center
speakers.
Sound settings (
SETTING1
,
SETTING2
or
SETTING3
)
Created acoustic sound field can be stored in
this unit and called up easily. Additionally, this
unit stores the sound setting and output chan-
nel information for each source group. Chan-
ging the source switches sound setting and
output channel information for each source
group at the same time.
Three types of sound settings can be set and
stored for both 2-channel mode and multi-
channel mode independently. Moreover,
sound settings can be stored for both the net-
work mode and the standard mode. Therefore,
a total of 12 types of sound settings can be set
and stored.
!
Auto TA and EQ (refer to
(auto-time alignment and auto-equalizing)
on page 96) can be performed only when
the standard mode is selected. Performing
Auto TA and EQ creates auto settings
(
AUTO
) which are adjusted finely for both
2-channel mode and multi-channel mode.
However,
AUTO
cannot be customized.
!
Auto TA and EQ (refer to
(auto-time alignment and auto-equalizing)
on page 96) is carried out depending on
the speaker setting (refer to
on page 91) in
SETTING1
.
Audio Adjustments
En
80
Section
17
