Pioneer Eclipse PE420GP, Operation Manual, Page: 17 / 52

Wheel Adjustment
1. Place machine in the Rok-Bak position. (See Rok-
Bak section)
NOTE: For burnishing, move wheels to one of the two
forward holes. For grinding or polishing, move wheels to
one of the two rear holes.
Solution Control Switch
The solution control switch controls the pump that pumps
solution from the tank to the floor.
Start: Press the right side of the switch.
Stop: Press the left side of the switch.
Note: Do not operate the pump without solution in the
tank. This can damage the pump.
Solution Control Valve
The solution control valve controls the solution flow to the
floor.
Increase: Turn the valve counter-clockwise.
Decrease: Turn the valve clockwise.
Stop: Turn the valve all the way clockwise.
Note: Even if the key switch is in the OFF position,
solution can still be dispensed on the floor. Take care to
turn the valve off when the machine is not in use.
Solution Tank
Filling the Solution Tank:
1. Push the machine to a level water filling station.
2. Turn the propane cylinder service valve clockwise
to close. When the engine has stopped, turn the
key switch to the OFF position.
3. Remove the solution tank lid.
4. Fill the tank with water. Capacity: 6 U.S. gal.
(22.7 L)
Emptying the Solution Tank:
1. Turn the propane cylinder service valve clockwise
to close. When the engine has stopped, turn the
key switch to the OFF position.
2. Unclip the open end of the solution tank drain
hose.
3. Open the solution tank drain valve.
11