45
TSP-16
5
6
7
8
5
6
7
8
A
B
C
D
E
F
PAGE
11 : AUDIO TEST
•
Mode for confirmation of the Audio Route
•
In MODE1
INPUT ---> output from OUT1-2/MA
S
TER, OUT3-4, OUT5-6, OUT7-
8
and PHONE
S
•
In MODE2
INPUT ---> via
S
ND DAC(IC6000)/RTN ADC(IC6001) ---> output from OUT7-
8
•
In MODE3
INPUT ---> via Analog Filter ---> output from OUT-1/2 and MA
S
TER
• When
LIMIT button is enabled (lit in green), execute a limiter by the hardware circuit to input line.
(In the case of gray will be limiter OFF)
* When the modes are switched, automatic fade-out / fade-in processing of sound volume is not carried out,
so the switching noise (popping sound) is output.
Before switching the modes, adjust the sound volume by turning OFF the volume of amplifier at output destination.
[PAGE 11] AUDIO TEST
PAGE
12 : FACTORY RESET
RE
S
ET
• This is the mode for
Factory Reset
•
Resets the setting values of utilities etc. to the factory shipment status excluding a part of setting by pressing
RE
S
ET button.
*
S
etting that is not reset to the factory shipment status by factory reset
•
PAD calibration
•
Touch panel calibration
S
etting of touch panel calibration that is set in the Test Mode is not reset to the factory shipment status
even if the factory reset is executed.
S
etting of touch panel calibration that is set for utilities is reset to the factory shipment status if the factory
reset is executed.
•
Language setting
[PAGE 12] FACTORY RESET
OFF
MODE1
MODE2
MODE3
LIMIT
