PIONEER DJ DJM-TOUR1, Manual

Page: 7 / 20

En
7
Part
names
and
functions
Part names and functions
Rear panel, front panel
PHONES
LINK
CH4 EXTENSION CH3 CH2 CH1
IN
OFF ON
75 Ω
MASTER2 REC OUT MASTER1
WORD CLOCK
DIGITAL OUT
INTERNET
DIGITAL IN BOOTH
AES/EBU
2 4 5 4 5 5 4 5 4 6 6 1 7 8
k
9 g h c b d j a f i e
3
1 Kensington security slot
2 POWER button (page 14 )
Turns this unit’s power on and off.
3 EXTENSION terminal (page 12 )
Used when extending PRO DJ LINK. Connect this to the LAN termi-
nal of a computer with rekordbox installed, etc.
4 PHONO terminals (page 12 )
Connect to a phono level (MM cartridge) output device. Do not input
line level signals.
To connect a device to the [
PHONO ] terminals, remove the short-
circuit pin plug inserted in the terminals.
Insert this short-circuit pin plug into the [
PHONO ] terminals when
nothing is connected to them to cut external noise.
5
LINE terminals (page 12 )
Connect to a DJ player or a line level output component.
6 SIGNAL GND terminal (page 12 )
Connects an analog player’s ground wire here. This helps reduce
noise when the analog player is connected.
7
MIC2 terminal (page 12 )
Connects a microphone here.
8 MIC1 terminal (page 12 )
Connects a microphone here.
9 INTERNET terminal
Connect to a router, etc. that is connected to the Internet. Used when
connecting with the KUVO system.
Connect a device to be connected to PRO DJ LINK not to this termi-
nal but to the [
EXTENSION
] terminal.
a DIGITAL IN terminal (page 12 )
Connect these to the digital coaxial output terminals on DJ players,
etc. The sound may be momentarily interrupted when the output
signal sampling frequency is switched.
b 75
Ω
termination ON/OFF switch
c WORD CLOCK input terminal
Set the external clock generator to MASTER and implement digital
master output synchronized with another device.
Use a cable with an impedance of 75 Ω for the connection between
the terminals. Performance is not guaranteed when a cable with an
impedance of other than 75 Ω is used.
Change the 75 Ω termination ON/OFF switch setting according to
the connection method.
— ON
—
For connecting with the external clock generator on a one-to-
one basis
—
For terminating with this unit when connecting a combina-
tion of multiple devices
—
OFF
—
For terminating with another device when connecting a
combination of multiple devices