HUNTER-PRO RSA Intruder Alarm System - User Manual for LCD keypads
36
CH. 5:
TROUBLESHOOTING
NOTE:
If more then one failure is detected, the display will scroll the failure list one after
the other. If more than one keypad is connected to the HUNTER-PRO, and you are
programming the system from one keypad, then the display on all other keypad will
display:
Other Keypad in Use
. This will also be displayed
whenever someone is in control of the HUNTER-PRO RSA via telephone.
The following table describes the possible Alarm System Faults:
Displayed Fault What can I do?
Battery
Wait approximately 24 hours for the indication to
disappear. If the fault indication persists longer then one
day, the back-up battery should be replaced.
Mains Fault
Usually appears during a power failure. If other electrical
appliances in the house are operating, check the switch
or fuse to which the alarm system is connected. If the
cause of the fault is unclear, call the technician.
Clock
Appears following a prolonged power failure during which
the backup battery was completely discharged. Set time
and date (see section
4.2)
Phone
Perform “system self-test” (see section
4.8). Verify during
the test that other instruments connected to the Alarm
System’s telephone line (i.e., telephone sets, facsimiles,
etc.) are not active. If the fault persists, call the
technician.
Tamper 1
Tamper switch 1 is open. Call the technician.
Tamper 2
Tamper switch 2 is open. Call the technician.
Summary of Contents for HUNTER-PRO RSA
Page 40: ...P N 4410211 Rev A Sep 2005...
