34
HUNTER-PRO Series & CAPTAIN 8 User Guide
The system does not recognize phone commands (tones) while sounding
the confirmation tone. Therefore, you must wait until the confirmation
tone is over, before pressing any phone key.
5.
Dial a number, according to the next table. The panel confirms every command
with two beeps.
Dial Action
0
Stop the external siren and the dialer
1
Arm the system
2
Disarm the system (if enabled by the technician)
4
Arm the system to “Home 1” mode
5
Switch on the onboard relay
6
Switch off the onboard relay
7
Arm the system to “Home 2” mode
8
Listen in for one minute (using MIC-200). Any more
press will extend the listen in time in one minute
•
While the system is communicating, the message “Other keypad in use” is
displayed on all the keypads.
•
If the panel does not receive any command for a period of 60 seconds, it
disconnects the call. It then remains in standby mode (with the above
message displayed on the keypads) for another 60 seconds, before the
message disappears.
•
During listen in, all other remote control commands are disabled.
14.2
Full mode
•
To control the panel in full mode:
1.
Repeat steps 1-4 in the previous Basic mode section.
2.
To trigger an output, press [*] and the corresponding command, as listed in the
following tables.
3.
To deactivate an output,
press [#] and the corresponding command from the
following tables.
General
Command
Dial
Turn off the external
siren and stop the dialer
*00
Arm the system
*01
Disarm the system
#01
Arm to “Home 1” mode
*04
Arm to “Home 2” mode
*07
Start listen in for 1 min.
*08
System’s outputs
Output
Dial
Ext. SIREN
11
Int. SIREN
12
RELAY
13
SMOKE
14
ON/OFF
15
ALARM
16
AUDIO Ctrl
17