Captain 6 Installation Guide
35
5.7
The Technician code
Technician code
Select:
CPTN XX en 6.10
Technician code
ENTER/NEXT/END
Technician code
******
enter a new (4-6 digit) Technician code
The technician code is displayed with asterisk and cannot be revealed otherwise.
If the code is lost, disconnect the control panel from any power for 10 seconds and
then re-connect it. For 30 seconds only, the system default codes (Master - 5555,
Technician - 1234) will be active.
If the lost code begins with zero, it cannot be defaulted and you should contact your vendor.
5.8
Defaulting the system & fast loading
5.8.1
Defaulting the system
Technician code
Select:
CPTN XX en 6.10
Defaults ?
ENTER/NEXT/END
Are you sure ?
ENTER/NEXT/END
to cancel the action
to proceed
...
14:20
------
The CAPTAIN 6 allows restoring of all system parameters to their factory defaults.
Defaulting erases all previous programming: memory, user codes, zone names, etc.
See “Appendix – Default system parameters” on page 40 for the factory defaults.
5.8.2
Fast parameter loading
Technician code
Select:
CPTN XX en 6.10
FAST-LOAD ?
(1-4)
the
program number to be downloaded from the PRG-22
/
/
/
Wait
for the process to end
FASTLOAD FINISH
This screen is used for downloading parameters to the control panel via the PRG-22
programmer.
The parameters are uploaded to the programmer by the COMAX upload/download software.
To start the downloading, connect the PRG-22 programmer to an LCD keypad. See
section 3.1 for instructions.
ENTR
ENTR
ENTR
ENTR
1
ON/OFF
3
BYPASS
