Captain 6 Installation Guide
24
5.2
Monitoring Station communication parameters
Technician code
Select:
CPTN XX en 6.10
Subscriber I.D
ENTER/NEXT/END
Subscriber
I.D
Ph:0 Rad:0
DblRep. or Part.
Ph:0 Rad:0
Station Format:
0 0 <T=0
Ack Time(sec) 20
Radio Trans. 5
Kissoff Delay
0
Frames in Tr.
13
Auto test hour
0 :0
Auto test time
0 hr. 0 min
GSM Unit
ENTER/NEXT/END
GERTP GSM Exists
_----
GSM Pre Number
5.2.1
PSTN & Radio subscriber IDs, Double Report
Technician code
Select:
CPTN XX en 6.10
Subscriber I.D
ENTER/NEXT/END
Subscriber
I.D
Ph:0 Rad:0
“Ph” - set the PSTN subscriber ID for Monitoring Station #1/Partition #1
“Rad” - set the Radio subscriber ID
DblRep. or Part.
Ph:0 Rad:0
to exit
-OR-
set the same parameters for
Monitoring Station #2 (“Double Report”) or Partition #2
In CAPTAIN 6, you can program a separate subscriber ID for the PSTN and the Radio reports.
A subscriber ID can have up to 4 digits.
The “Double Report/Partition” screen enables you to program a second ID if the control
panel reports to a second Central Monitoring Station, or if Partition #2 is in use. The
options of using the second IDs are listed in the next table.
I.D=0 is as if no subscriber number is programmed
The largest subscriber number for the PIMA format is 8000.
5.2.2
Station format, ACK, Kissoff delay
Technician code
Select:
CPTN XX en 6.10
Subscriber I.D
ENTER/NEXT/END
X3
Station Format:
0 0 <T=0
the PSTN format
3
(“0 0”) and Radio station number (“T”)
Ack Time(sec) 20
Radio Trans. 5
set the ACK waiting time (in seconds) and the Radio re-transmission number
4
Kissoff Delay
0
set the waiting for Kissoff delay (in 250ms increments per number)
3
To use ContactID, set the format to “0 230”.
4
The delay between the transmissions is 10 sec. and is not programmable.
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
ENTR
