Commissioning
Operating Manual PSENvip RL D P Set
1001641-EN-09
| 70
The receiver is correctly aligned with the transmitter when:
}
The cross-hairs of both adjustment templates overlap
}
The quadrants form a full circle and
}
The centre point of the upper tool is on the bending line.
The correct adjustment image on the display will look like the image shown in the illustra-
tion below.
Fig.: Correct adjustment image
INFORMATION
The adjustment templates have different cut-outs around the cross-hair (see
section entitled "Adjustment templates"). This makes it easier to evaluate
the adjustment direction required by the transmitter and receiver.
}
Adjust the direction of the receiver as described in the section entitled "Adjustment direc-
tions of transmitter and receiver".
}
Remove the adjustment templates.
The correct adjustment image on the display will look like the image shown in the illustra-
tion below:
}
The bending line should be on the vertical guide.
}
The tool centre point should be aligned with the horizontal guide (the horizontal guide is
firmly in the middle of the range bar (see section entitled "Make adjustment during tool
change").
