Safety
Operating Manual PMI v704e/v707e
1003980-EN-02
11
3
Safety
3.1
Intended use
This device is used to create a point-to-point connection with a PNOZmulti device, to oper-
ate and to monitor the device.
CAUTION!
The unit is not designed for use in applications with stringent safety require-
ments (e.g. E-STOP).
The following is deemed improper use in particular
}
Any component, technical or electrical modification to the product,
}
Use of the product outside the areas described in this manual,
}
Use of the product outside the technical details (see
Technical details [
36]
).
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
3.1.1
Supported hardware and software
}
PNOZmulti base units from the following versions:
– Configurable safety systems PNOZmulti
- PNOZ m0p from Version 2.0
- PNOZ m1p from Version 5.0
- PNOZ m2p from Version 2.0
– Configurable compact controllers PNOZmulti Mini
- PNOZ mm0.1p from Version 1.0
- PNOZ mm0.2p from Version 1.0
– Configurable compact controllers PNOZmulti 2
- PNOZ m B0 from Version 1.0
- PNOZ m B1 from firmware Version 1.1.1
}
PNOZmulti Configurator from Version 10.x.x
}
PASvisu Builder from Version 1.6.x
Further information on PASvisu can be found in the PASvisu online help.
