PSEN ma2.1p-34
Operating Manual PSEN ma2.1p-34
22192-EN-07
| 7
Disposal
}
In safety-related applications, please comply with the mission time T
M
in the safety-related
characteristic data.
}
When decommissioning, please comply with local regulations regarding the disposal of
electronic devices (e.g. Electrical and Electronic Equipment Act).
For your safety
WARNING!
Loss of safety function due to manipulation of the interlocking device
Manipulation of the interlocking device may lead to serious injury and death.
– You should prevent any possibility of the interlocking device being
manipulated through the use of a spare actuator.
– Keep the substitute actuator in a safe place and protect it from unau-
thorised access.
– If spare actuators are used, these must be installed as described in
Installation [
13]
.
– If the original actuators are replaced with substitute actuators, the ori-
ginal actuators must be destroyed before disposal.
}
Do not remove the connector's protective cap until you are just about to connect the unit.
This will prevent potential contamination.
}
The connector should be protected from accidental loosening (e.g. using a cable tie).
WARNING!
Ignition spark from cable separator/connector within the potentially
explosive area can trigger an explosion
When the cable separators/connectors are used within the potentially ex-
plosive area, sparks can be caused and lead to an explosion.
– Make sure that the cable separators/connectors are used only within
the potentially explosive area.
}
The IP protection type (see
Technical details [
17]
) has been determined in accord-
ance with DIN EN 60529 with a safety switch that is as new.
Unit features
}
The actuator PSEN 2.1-10 belongs to the safety switch.
}
Coded actuator
}
Safety switch with 4-pin M8 male connector
}
2 safety contacts (reed contacts - N/C and N/O)
}
Design: Square
}
Operation Magnetic
