9
Quickly pressing the Sync / Multi switch turns the synchronization between the two loops on and off.
When Sync is off, the button is not lit. In this mode, the lengths of the two loops are unrelated and
playback is not synchronized.
When Sync is selected (RED), the lengths of the two loops are synchronized at a 1:1 ratio.
Holding down the SYNC / MULTI button turns the switch ORANGE and activates the SYNC options
menu, allowing you to alter the ratio between the two loops using the rotary encoder to select a
value between 1 and 99. Any value greater than 1:1 will cause the button to turn GREEN to indicate
that the sync value is set to a multiplier value greater than 1:1. Push and hold the SYNC / MULTI
button any time to check or change your multiplier value.
When the two loops are in SYNC, Loop 1 sets the initial length. Once recording on Loop 2 is initiated,
the Arm light will blink and it will wait to begin recording until the top of the next loop cycle. Loop
2 will automatically stop recording and begin playback when the proper length multiple has been
reached.
You can alter the sync multiplier at any time while recording, by manually closing Loop 2 with the
Loop 2 footswitch. This will cause Loop 2 to close at the end of the current loop cycle. The arm light
will blink to indicate that Loop 2 is about to close. To cancel this operation, hit the Loop 2 footswitch
again and it will continue recording until the full multiplier factor has been reached.
Once Loop 2 is recorded, the Sync is locked to the multiplier you have selected. It is possible to
turn Sync on and off at this point, but you must delete Loop 2 if you want to switch to a different
multiplier value.
Once Loop 2 is recorded, its length is fixed. However, turning Sync off after that point allows you to
start playback of Loop 2 at any time, not just at the start of Loop 1. When Sync is on, Loop 2 will
always replay from the start of Loop 1.
During recording, whichever loop is armed will automatically close once you hit the maximum
allowable length. Overall recording time for Loop 1 is dependent on the multiplier value you’ve
selected for the current preset, the size of the memory card you have installed in your Infinity 3,
and the number of preset slots you have assigned. If the loop you are trying to create is too long
for the current setting, lower the multiplier value or reduce the number of presets.
Toggle Switches
SYNC / MULTI